RC Detail of Upstands:

-

 Upstands:

If height is Greater than 500mm,




If height is less than or equal to 500mm,



If height is less than or equal to 300mm,


If  Upstand is less than or equal to 150mm thickness,






Comments

Post a Comment

Popular posts from this blog

Placement Plane and Orientation of shape driven rebar

-
Image
 This is meant as a brief overview of the options that exist during shape driven rebar placement. A shape driven rebar gets its geometry from a rebar shape loaded into the Revit project. This kind of rebar has a bar plane that contains all the bar geometry, segment planes perpendicular to the bar plane, which contain each segment, as well as an out of plane extent, which represents the end of the rebar set. To place such a bar in any 2D view, we need to position and orient it within the element and relative to the view plane. Here’s a simple example of placing the M_17 shape: • In a section view you can place the single bar in the current workplane, at the far end of the element (detected automatically) or at the near face of the element o Placing a single bar in a section like this, at the near cover reference, will show a warning that the bar is not visible • When placing a set in this section, the result is the same, regardless of the placement plane setting Placement orie...
Read more

REBAR DETAILING OF FOUNDATION

-
Image
 Foundations  SCOPE:   Pile cap   Pad   Strip footing   Raft   SOG (SLAB ON GRADE) DETAILING STANDARDS:  Nominal Cover to Reinforcement: Internal : (25mm or bar size) + ΔCdev (5 or 10mm)  External : 35mm + ΔCdev (5 or 10mm)  Earth face : 45mm + ΔCdev (5 or 10mm)  Bottom cover for Piled foundations : 100mm (or 75mm)  Spacing and Size of bars:   Minimum spacing : 75mm (at laps)  Maximum spacing : 300mm  Minimum bar size : 16mm (Except for lacers) Bar arrangements:   TYPICAL PILE CAP BAR ARRANGEMENT ALTERNATE METHOD OF TWO PILE CAP ALTERNATE METHOD OF THREE PILE CAP Pad Footings: Strip footings:       Raft: Starters from Foundations:    Steps in Foundations: Recess in Raft or Slab:   SOG: (SLAB ON GRADE) Corner Details for Edge Thickening: Side Bars Arrangements Edge Thickening:  Slab Thickening Sections: Where, T A is Tension anchorage T L is Tension Lap
Read more

Best tips for Revit beginners

-
Image
  10 Best practices for Revit beginners Autodesk Revit is a great BIM tool for architects, engineers, designers and contractors. Yet, a tool is as good as its user, and the full potential of modeling in Revit can only be understood through a deep understanding of its various functions. Here are some important tips to help you make the most of Revit and speed up the modeling process. 1. Move from 2D, think 3D One of the biggest challenges with Revit is to move from 2D thinking to 3D thinking. Both professionals and students that came in my Revit classes during the past years were comfortable with how they did things and didn’t understand why change is needed. I must admit that when I started with Revit, (10 years ago) I did exactly the same. I was still thinking in a 2D Construction Document way. I was looking for a way to do the things I was used to, rather than adopting a new way of working. But eventually, I realized the full potential of the BIM process and technology and...
Read more